Paid plugin · Channel compressor · Windows & macOS · 14-day trial

Ferrule 35

Ferrule 35 is a one-slot channel compressor with a feedback, symmetric full-wave rectifier detector, six ratios (1.5:1 to 8:1), six TIMING positions with a FAST switch, PUSH, a sidechain high-pass, MIX and an external sidechain input. A BLOOM stage (Air or Body, Satin or Iron) adds an output-stage voice. Stereo, Summed S/C, Dual Mono and M/S, with a 14-day full trial and an offline licence.

How the trial works

Ferrule 35 -- the module
Ferrule 35 walkthrough on drums.
At a glance

The facts, in numbers

CompressorFeedback; a symmetric full-wave rectifier detector at the oversampled rate; RATIO 1.5, 2, 3, 4, 6 or 8 to 1 (the engraving is nominal, the manual shows the effective ratio); knee 6 dB wide
TimingTIMING FAST, MF, MED, MS, SLOW or AUTO, and a FAST switch that halves every time constant. The table is printed in the manual
RangesTHRESH -50 to 0 dBFS; GAIN -6 to +20 dB; MIX 0 to 100 percent; SC HPF OFF or 20 to 250 Hz; external sidechain input
PUSH+20 dB into the compressor and -20 dB out of it: the compressor works 20 dB harder and the colour stage is driven hot
BLOOMAn output-stage voice: Off, Air or Body, AMOUNT 0 to 100 percent, with two engines (Satin or Iron) in the options menu
OversamplingOff / 2x / 4x / 8x, Minimum or Linear phase; default 2x Minimum
Latency0 samples with oversampling Off; 3 / 4 / 5 at 2x / 4x / 8x Minimum; 129 / 139 / 142 at Linear phase. While Iron is selected: 14 / 6 / 5 Minimum and 140 / 141 / 142 Linear
Presets34 factory presets: Init plus 33 starting points in eight categories
StereoMono or stereo instance; Stereo, Summed S/C, Dual Mono, M/S
DisplaysGain-reduction VU, Comp Curve, GR History and SC EQ pages; IN / GR / OUT meters
Controls

Every control on the strip

Ctrl / Cmd while dragging moves a control in exact steps of its displayed unit.

COMP INPuts the compressor in and out.
THRESH, GAINTHRESH -50 to 0 dBFS (a fresh instance compresses nothing); make-up GAIN -6 to +20 dB.
RATIO, TIMING, FASTSix ratios and six TIMING positions; FAST halves every time constant.
PUSHOrange lamp. +20 dB into the compressor and -20 dB out of it.
SC HPF, MIXA high-pass on what the detector hears (it never filters the audio); MIX blends the uncompressed signal back in.
BLOOM, AMOUNTOff, then AIR (red lamp), then BODY (blue lamp), one step per click; AMOUNT is how much.
Options menuInternal or external key, Bloom engine (Satin or Iron), Mix Law (Crossfade or Parallel), VU meter (GR or Output), oversampling.
General sectionDisplay, IN / GR / OUT meters, IN and OUT trims, stereo-mode selector, power switch. UI size 75-200%
Try before you buy

14 days, every feature

The free trial is on the Ferrule 35 Gumroad page: the button below opens it; press Start the free 14-day trial there (price 0) for the Ferrule 35 installers for Windows and macOS. Install, insert Ferrule 35 in your host and press Start Free Trial inside the plug-in: 14 days, full features, full audio quality, no watermark. The clock starts when you press Start Free Trial, not when you download. Each Ferrule product has its own 14 days. When you buy, the same installation unlocks -- nothing to reinstall. Gumroad may ask for an email address to deliver the files.

We do not offer refunds on paid purchases -- the trial is how you decide. Your statutory rights are not affected. Refund policy

Known limits

What is not perfect, plainly

We ship disclosure, not marketing. These are the known limits of Ferrule 35 1.0.0; the manual carries the full list, and the Ferrule FAQ answers the common questions.

  • The level just after a preset load. In a test with steady tones (every factory preset loaded from Init and from its neighbours, oversampling Off and at its default setting), a 60 Hz tone never rose above the 1.0 dB line (the worst was 0.85 dB). Tones at 900 Hz and 8 kHz did on 36 of 392 loads, by up to 2.56 dB, peaking about 8 ms after the load (Init to Parallel smash, in Drums, oversampling Off, 8 kHz). On programme material a few factory presets still swell for a moment after a load, mostly with oversampling Off: up to 1.65 dB for about 10 to 17 ms at 48 kHz (Electric sustain in Guitar; Parallel smash in Drums 1.36, Driven growl in Bass 1.28, Parallel weight in Vocal 1.01), up to 1.8 dB in Summed S/C and M/S, 2.4 dB with the external key and 2.9 dB at 96 kHz with 64-sample blocks. After a load the level can then sit up to 2.3 dB under the settled level for a moment (Piano gentle in Keys).
  • The IN and OUT trims glide in dB over 50 ms, with no corner at either end: a move that is reversed halfway turns from where it is, and a move never passes its target. Moving IN and OUT in opposite directions at the same moment does not bump the level. In a test of single trim moves (60 Hz, 900 Hz and 8 kHz tones) the largest change of slope read at most 1.02 times the signal's own on every Ferrule product (the line is 1.10); a switch that changes the latency, made inside an IN move, adds no dip of its own.
  • A switch that changes the latency (the oversampling mode or phase and, where this product has them, the Bloom engine, Flutter or Look) fades the output out over 5 ms, holds silence and fades it back in over 5 ms. For an oversampling change the whole mute lasts about 21 ms into minimum phase or Off and about 22 to 24 ms into linear phase at 44.1 and 48 kHz, about 18 and 19 ms at 96 kHz. If the IN trim was moved within the last 50 ms, the silence lasts until that move has finished (up to about 50 ms longer). In a test of such switches on every Ferrule product the largest sample-to-sample step on a 40 Hz tone read at most 1.086 times the signal's own (the line is 1.10). Content below 24 Hz inside the mute is not covered by that reading.
  • A specification, not a measurement. The controls and time constants follow a published specification; the units we analysed were used for the voice only. No match to any specific device is claimed.
  • TIMING is a declared table of this plug-in, one central value per position; it differs from the units we analysed on purpose (their fast side reads 7.7 to 13.2 ms). RATIO is nominal: 3:1 to 8:1 reach the engraved slope 30 to 40 dB above THRESH, and the knee is 6 dB wide.
  • The detector is a symmetric full-wave rectifier. The analysed units carry a fundamental-period ripple under gain reduction that is not reproduced.
  • Jumping SC HPF while a signal is being compressed adds up to 0.61 dB of gain reduction beyond the law for a few milliseconds (FAST, MF and MED at 6:1 and 8:1). THRESH and RATIO moves add none.
  • Iron latency. While Iron is the selected engine the reported latency is the oversampling chain's plus a fixed extra (for example 14 instead of 3 at 2x Minimum). Changing the engine at 2x or 4x mutes briefly and the latency jumps. With Satin selected the lower figure is reported; with Iron selected the extra stays even while BLOOM is Off.
  • Iron at 4x has an alias line at -94.0 dBc (48 kHz, AIR 100 percent, 19 kHz tone at -6 dBFS); the default 2x reads -103.3 dBc and Linear phase -122.3 dBc. With PUSH on, Iron aliases more: at 44.1 kHz and 2x, +18 dB of drive into AIR 100 percent reads -53.4 dBc.
  • The high-drive colour stage at the default 2x folds at -56 to -49 dBc when PUSH is on and the input is at 0 to +6 dBFS. Use 4x or 8x for sounds driven that hard.
  • Intermodulation under gain reduction: a low tone's detector ripple modulates higher tones (60 Hz + 7 kHz at -18 dBFS, 48 kHz, 2x: -53.7 dB at about 9 dB of gain reduction in MED, -44.0 dB in FAST).
  • A brief high-frequency dip of up to -0.92 dB at host bypass and COMP IN hand-over with Minimum-phase oversampling.
  • CPU. Iron costs about four to seven times the load of BLOOM Off, Satin about one and two thirds times. Use Satin where the CPU matters.
  • With the power rocker Off and BLOOM = Body the blue lens stays unlit.
  • After the trial, the plug-in passes audio dry. That includes an offline bounce or export, so check the trial or licence status first if a render comes out unprocessed.
  • A licence added while an instance is open is read the next time that instance loads. Reopen the session if another instance still shows the trial badge.
  • Not every host on every platform has been tested. The main verification host is Studio One; Logic (macOS), Pro Tools (AAX) and the macOS builds are checked separately, and every figure on this page is a reading of the Windows build.
Specifications

Formats & requirements

DeveloperGANUE Audio
Version1.0.0
WindowsWindows 10 or later (64-bit): VST3, AAX
macOSmacOS 11.0 or later: VST3, AU, AAX (one Universal build, Apple Silicon and Intel; signed and notarized)
StandaloneNone
LicenceOffline licence file, no iLok, no account, no online activation, no expiry
Trial14 days, full features
PriceUSD 19 until Nov 30, 2026, then USD 29USD 29. Also in the Ferrule Modern Collection and the Ferrule Complete Collection
SHA-256, Windows installer6c8c405fc6ee866128113d35b38a6aadfd33b6f2b9452aeaf98f17323ad57797
SHA-256, macOS installer0ecb0c113abccfae0a2d17fc2ac4d6fb1c7e62c2e2f01a3ad16d3b619a6e2860
Buy · v1.0.0

Get Ferrule 35

USD 19 until Nov 30, 2026, then USD 29USD 29. Windows & macOS. 14-day full trial first.

Also in the Ferrule Modern Collection (Ferrule 51 (free) with 33, 35, 42 and 43): USD 49 until Nov 30, 2026, then USD 69USD 69; and in the Ferrule Complete Collection (all ten plug-ins): USD 89 until Nov 30, 2026, then USD 119USD 119.

Checkout is handled by Gumroad. Your licence file and the installer links arrive in a separate email from [email protected]; drag the file onto the Ferrule 35 window and it unlocks, offline. The PDF manual is included. EULA

By continuing to checkout you agree to the EULA and the Refund Policy.